Справочное Руководство для Intermec 9710
C d 39
IBM 7552
49
IBM 7552
This section covers the IBM 7552 workstation. The individual Wedge Interface Guide
corresponding to this section is part number 055821.
corresponding to this section is part number 055821.
Cables
Connecting the reader to the IBM 7552 workstation requires two cables: a keyboard
cable and a terminal cable. The interface kit contains both the keyboard and terminal
cables. If you need to order a replacement cable, use the part numbers listed below:
cable and a terminal cable. The interface kit contains both the keyboard and terminal
cables. If you need to order a replacement cable, use the part numbers listed below:
• Wedge interface kit (P/N 055820)
• Keyboard cable (P/N 055819)
• Terminal cable (P/N 055818)
• Keyboard cable (P/N 055819)
• Terminal cable (P/N 055818)
Power Supply
The reader does not require an external power supply to work with the workstation. Set
the PCB jumper to connect pins 1 and 2 on the reader’s rear panel.
the PCB jumper to connect pins 1 and 2 on the reader’s rear panel.
Configuring the Reader
Scan this label to configure the reader for your workstation. After the label is scanned,
the reader emits one low beep followed by four low beeps. The four low beeps indicate
the reader has successfully stored the configuration and is ready to read labels. If the
reader emits a different beep sequence, refer to the Wedge Reader User’s Manual,
Section 2, for beeper identification.
the reader emits one low beep followed by four low beeps. The four low beeps indicate
the reader has successfully stored the configuration and is ready to read labels. If the
reader emits a different beep sequence, refer to the Wedge Reader User’s Manual,
Section 2, for beeper identification.
IBM 7552
*$+TA319*
*$+TA319*