Справочное Руководство для Intermec 9710
C d 39
IBM PC/XT/AT Series
51
Configuring the Reader
Scan the appropriate label to configure the reader for your workstation. After the label is
scanned, the reader emits one low beep followed by four low beeps. The four low beeps
indicate the reader has successfully stored the configuration and is ready to read labels.
If the reader emits a different beep sequence, refer to the Wedge Reader User’s Manual,
Section 2, for beeper identification.
scanned, the reader emits one low beep followed by four low beeps. The four low beeps
indicate the reader has successfully stored the configuration and is ready to read labels.
If the reader emits a different beep sequence, refer to the Wedge Reader User’s Manual,
Section 2, for beeper identification.
To Set Workstation Configuration to
Scan This Bar Code
Alfaskop DS/DT*
*$+TA171*
*$+TA171*
AST 286/386
*$+TA327*
*$+TA327*
AT&T 605
*$+TA2*
*$+TA2*
Compaq 286/386
*$+TA114*
*$+TA114*
HP Vectra ES
US Keyboard
US Keyboard
*$+TA75*
*$+TA75*
HP Vectra ES
Belgian Keyboard
Belgian Keyboard
*$+TA86*
*$+TA86*
HP Vectra ES
Danish Keyboard
Danish Keyboard
*$+TA83*
*$+TA83*
HP Vectra ES
French Keyboard
French Keyboard
*$+TA78*
*$+TA78*
HP Vectra ES
French Canadian Keyboard
French Canadian Keyboard
*$+TA85*
*$+TA85*
HP Vectra ES
German Keyboard
German Keyboard
*$+TA76*
*$+TA76*