Справочное Руководство для Intermec 9710

C d 39

This section covers these workstations: 

•  I-O Corporation 1181D 

•  I-O Corporation 1197 

•  I-O Corporation 1181EP 

•  I-O Corporation 2196 

•  I-O Corporation 1181ES 

•  I-O Corporation 2476C 

•  I-O Corporation 1181WP 

•  I-O Corporation 2497C 

•  I-O Corporation 1196 

•  I-O Corporation 2497D 

•  I-O Corporation 1196D 

 

The individual Wedge Interface Guide corresponding to this section is part number 
055873. 

Connecting the reader to one of these workstations requires two cables: a keyboard 
cable and a terminal cable. The interface kit contains both the keyboard and terminal 
cables. If you need to order a replacement cable, use the part numbers listed below: 

•  Wedge interface kit (P/N 055872) 
•  Keyboard cable (P/N 055871) 
•  Terminal cable (P/N 055870) 

The reader does not require an external power supply to work with the workstation. 
Even though the reader does not require a power supply, set the PCB jumper to connect 
pins 2 and 3 on the reader’s rear panel. This is an exception for the I-O Corporation 
workstations. 

Scan the appropriate label to configure the reader for your workstation. After the label is 
scanned, the reader emits one low beep followed by four low beeps. The four low beeps 
indicate the reader has successfully stored the configuration and is ready to read labels. 
If the reader emits a different beep sequence, refer to the Wedge Reader User’s Manual, 
Section 2, for beeper identification. 

I-O Corporation 
83-key Keyboard 

*$+TA321* 

 

*$+TA321*