Справочное Руководство для Intermec 9710
LynkLyte Series
C d 39
58
LynkLyte Series
This section covers the LynkLyte 1 workstation. The individual Wedge Interface Guide
corresponding to this section is part number 055756.
corresponding to this section is part number 055756.
Cables
Connecting the reader to the LynkLyte workstation requires two cables: a keyboard
cable and a terminal cable. The interface kit contains both the keyboard and terminal
cables. If you need to order a replacement cable, use the part numbers listed below:
cable and a terminal cable. The interface kit contains both the keyboard and terminal
cables. If you need to order a replacement cable, use the part numbers listed below:
• Wedge interface kit (P/N 054849)
• Keyboard cable (P/N 054848)
• Terminal cable (P/N 054847)
• Keyboard cable (P/N 054848)
• Terminal cable (P/N 054847)
Power Supply
The reader does not require an external power supply to work with the workstation. Set
the PCB jumper to connect pins 1 and 2 on the reader’s rear panel.
the PCB jumper to connect pins 1 and 2 on the reader’s rear panel.
Configuring the Reader
Scan the appropriate label to configure the reader for your workstation. After the label is
scanned, the reader emits one low beep followed by four low beeps. The four low beeps
indicate the reader has successfully stored the configuration and is ready to read labels.
If the reader emits a different beep sequence, refer to the Wedge Reader User’s Manual,
Section 2, for beeper identification.
scanned, the reader emits one low beep followed by four low beeps. The four low beeps
indicate the reader has successfully stored the configuration and is ready to read labels.
If the reader emits a different beep sequence, refer to the Wedge Reader User’s Manual,
Section 2, for beeper identification.
To Set Workstation Configuration to
Scan This Bar Code
LynkLyte 1 (5 pin PC/XT DIN)
102-key Keyboard
102-key Keyboard
*$+TA307*
*$+TA307*
LynkLyte 1 (7-pin DIN)
122-key Keyboard
122-key Keyboard
*$+TA306*
*$+TA306*