Справочное Руководство для Intermec 9710

Скачать
Страница из 109
C d 39
 Memorex/Telex Series 
63 
 
Memorex/Telex Series 
This section covers these workstations: 
•  Memorex/Telex 1191 
•  Memorex/Telex 1471 
•  Memorex/Telex 1192 
•  Memorex/Telex 1472 
•  Memorex/Telex 1196 
•  Memorex/Telex 1476 
•  Memorex/Telex 1197 
•  Memorex/Telex 1477 
 
•  Memorex/Telex 2296 
The individual Wedge Interface Guide corresponding to this section is part number 
054303. 
Cables 
Connecting the reader to one of these workstations requires two cables: a keyboard 
cable and a terminal cable. The interface kit contains both the keyboard and terminal 
cables. If you need to order a replacement cable, use the part numbers listed below: 
•  Wedge interface kit (P/N 054302) 
•  Keyboard cable (P/N 054301) 
•  Terminal cable (P/N 054300) 
Power Supply 
The reader does not require an external power supply to work with the workstation. Set 
the PCB jumper to connect pins 1 and 2 on the reader’s rear panel. 
Configuring the Reader 
Scan the appropriate label to configure the reader for your workstation. After the label is 
scanned, the reader emits one low beep followed by four low beeps. The four low beeps 
indicate the reader has successfully stored the configuration and is ready to read labels. 
If the reader emits a different beep sequence, refer to the Wedge Reader User’s Manual
Section 2, for beeper identification. 
To Set Workstation Configuration to 
Scan This Bar Code 
Memorex/Telex 1191 
88-key Keyboard 
*$+TA361* 
 
*$+TA361*