Руководство По Установке для Citel 1100

EXTender 1100A Remote Module: Quick Installation Guide

Setting up the COM Port

The Remote Module can be configured through the serial port when using a
terminal emulator such as Windows HyperTerminal. The following are the steps
necessary to access the Remote Module’s Management Console.

1. Start a HyperTerminal session. On a default installation of Windows XP, for

example, at the Start menu select Programs, Accessories,
Communications and finally HyperTerminal.

2. Enter a name for the new connection in the Name box – Remote, for

example

3. Select the COM port you are using from the options in the Connect drop-

down list

4. Check the configuration of the communications port and make sure that the

settings are as follows:

Bits per second

9600

Data bits

Parity None

Stop bits

Flow Control

None

5. Plug the power supply in to the Remote Module and then into the AC wall

outlet. Allow the unit to complete the bootup sequence.

6. Wait a few seconds and the “Press ‘Enter’ to start the shell…” prompt is

displayed.

7. Press Enter. A password prompt is displayed if a password is set (there is no

default password).

If the Remote Module is running but you do not see these prompts the serial
connection between your computer and the unit may be at fault. You must
correct this problem before you can use the HyperTerminal connection
successfully.

8. Type the unit’s password, if one was set, and press Enter. The Management

Console welcome screen is displayed

9. To ensure that you can see all the information displayed you must set the

screen size to 24 lines by 80 columns. The screen size is correctly set when
the Welcome screen is displayed with the ‘#’ border.