Инструкции Пользователя для Calflame bbq07877p

Page 6 

2007 Pizza Oven Owner’s Manual

 

LTR20071039, Rev. A

Your Cal Flame™ pizza oven is designed for easy 

installation into a non-combustible enclosure. The 

supporting deck or counter must be flat and level. 

When determining the final location of your pizza oven, 

adequate cross ventilation must be present to prevent 

gas from being trapped in the event of a leak. 
The drawing at right shows the cut-out dimensions for 

the drop-in pizza oven. 
Before installing a drop-in pizza oven in any island or 

cut out, make sure that the opening is not bigger than 

the outside frame of the pizza oven. The pizza oven 

should rest on the lip of the frame.
Pay careful attention to the location of gas lines. Gas 

lines should be routed away from sources of heat and 

should make as few bends as possible. Check to see if 

gas line connections will be accessible when the pizza 

oven is installed.
If gas line connections are not easily accessible when 

the pizza oven is installed, support the pizza oven 

above counter level and attach the gas lines. When the 

gas connections are made, slide the pizza oven into 

the cut out.

If gas line connections 

are accessible when 

the pizza oven is 

installed, slide the 

pizza oven into the 

cut out and then 

attach the gas lines.
Be very careful not to 

kink gas lines when 

lowering the pizza 

oven into the cut out.
You will need a 

second person 

to help you to avoid damaging your pizza oven or 

barbecue island.
Keep your fingers away from where the pizza oven will 

be supported on counter. Your fingers could become 

trapped and serious injury could occur.
Check to make sure the pizza oven is level and is 

supported around the entire outside edge. If the pizza 

oven is not level or is unstable, use non-combustible 

shims under the outside lip to stabilize it.

17 ½”

23 ¼”

9 ½”

The pizza oven uses three white bricks for diffusing 

heat from the burners.
After you have removed the pizza oven from the box 

and removed all packing materials, place the three 

racks lengthwise on the left and right ledge above the 

burner. Then place the three white bricks on the racks 

in the same way.
Remove the packing material from the rack and slide it 

in place on top of the bricks.