Инструкции По Установке для 3com S7906E
1-14
To do…
Use the command…
Remarks
Assign the interface to the
protected VLANs of the current
RRPP domain
protected VLANs of the current
RRPP domain
port trunk permit vlan
{ vlan-id-list | all }
{ vlan-id-list | all }
Optional
By default, an interface only
allows packets of its default
VLAN to pass through.
allows packets of its default
VLAN to pass through.
Disable STP
undo stp enable
Required
Enabled by default
z
For detailed information about the port link-type trunk command and port trunk permit vlan
{ vlan-id-list | all } command, refer to VLAN Commands in the Access Volume.
z
For detailed information about the undo stp enable command, refer to MSTP Commands in the
Access Volume.
z
Do not enable OAM remote loopback function on an RRPP port. Otherwise, this may cause
temporary broadcast storm.
z
You are recommended to use the link-delay command to enable link status rapid report function
on an RRPP port by setting the link-delay of the port to 0 to accelerate topology convergence. For
detailed information about the link-delay command, refer to Ethernet Port Commands in the
Access Volume.
Configuring RRPP Nodes
z
The maximum number of rings that can be configured on a device in all RRPP domains is 16.
z
If a device carries multiple RRPP rings in an RRPP domain, only one ring can be configured as the
primary ring on the device and the role of the device on a subring can only be an edge node or an
assistant-edge node.
Specifying a master node
Perform this configuration on a device to be configured as a master node.
Follow these steps to specify a master node:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter RRPP domain view
rrpp domain domain-id
—