Инструкции По Установке для 3com S7906E
1-15
To do…
Use the command…
Remarks
Specify the current device as the
master node of the ring, and
specify the primary port and the
secondary port
master node of the ring, and
specify the primary port and the
secondary port
ring ring-id node-mode master
[ primary-port interface-type
interface-number ] [ secondary-port
interface-type interface-number ] level
level-value
[ primary-port interface-type
interface-number ] [ secondary-port
interface-type interface-number ] level
level-value
Required
Specifying a transit node
Perform this configuration on a device to be configured as a transit node.
Follow these steps to specify a transit node:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter RRPP domain view
rrpp domain domain-id
—
Specify the current device as a
transit node of the ring, and
specify the primary port and the
secondary port
transit node of the ring, and
specify the primary port and the
secondary port
ring ring-id node-mode transit
[ primary-port interface-type
interface-number ] [ secondary-port
interface-type interface-number ] level
level-value
[ primary-port interface-type
interface-number ] [ secondary-port
interface-type interface-number ] level
level-value
Required
Specifying an edge node
When configuring an edge node, you must first configure the primary ring before configuring the
subrings.
Perform this configuration on a device to be configured as an edge node.
Follow these steps to specify an edge node:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter RRPP domain view
rrpp domain domain-id
—
Specify the current device as a
transit node of the primary ring,
and specify the primary port
and the secondary port
transit node of the primary ring,
and specify the primary port
and the secondary port
ring ring-id node-mode transit
[ primary-port interface-type
interface-number ] [ secondary-port
interface-type interface-number ] level
level-value
[ primary-port interface-type
interface-number ] [ secondary-port
interface-type interface-number ] level
level-value
Required
Specify the current device as
the edge node of a subring, and
specify the edge port
the edge node of a subring, and
specify the edge port
ring ring-id node-mode edge [ edge-port
interface-type interface-number ]
interface-type interface-number ]
Required
Specifying an assistant-edge node
When configuring an assistant-edge node, you must first configure the primary ring before configuring
the subrings.
Perform this configuration on a device to be configured as an assistant-edge node.
Follow these steps to specify an assistant-edge node: