Справочное Руководство для 3com S7906E

 

1-3 

After you specify to perform local password authentication, when a user logs in through the Console 

port, a user can log into the switch even if the password is not configured on the switch. But for a VTY 

user interface, a password is needed for a user to log into the switch through it under the same 

condition. 

By default, users logging in through the Console port are not authenticated, whereas modem users and 

Telnet users are authenticated. 

 

For VTY user interface, if you want to set the login authentication mode to none or password, you must 

first verify that the SSH protocol is not supported by the user interface. Otherwise, your configuration 

will fail. Refer to 

. 

 

# Configure to authenticate users using the local password. 

<Sysname> system-view 

System View: return to User View with Ctrl+Z. 

[Sysname] user-interface aux 0 

[Sysname-ui-aux0] authentication-mode password 

auto-execute command text 

User interface view 

3: Manage level 

text: Command to be executed automatically. 

Use the auto-execute command command to set the command that is executed automatically after a 

user logs in. 

Use the undo auto-execute command command to disable the specified command from being 

automatically executed. 

Use these two commands in the VTY user interface only. 

Normally, the telnet command is specified to be executed automatically to enable the user to Telnet to a 

specific network device automatically.