Справочное Руководство для 3com S7906E

 

1-4 

By default, no command is automatically executed. 

 

z 

The auto-execute command command may cause you unable to perform common configuration 

in the user interface, so use it with caution. 

z 

Before executing the auto-execute command command and save your configuration, make sure 

you can log into the switch in other modes and cancel the configuration. 

 

# Configure the telnet 10.110.100.1 command to be executed automatically after users log into VTY 0. 

<Sysname> system-view 

System View: return to User View with Ctrl+Z. 

[Sysname] user-interface vty 0 

[Sysname-ui-vty0] auto-execute command telnet 10.110.100.1 

% This action will lead to configuration failure through ui-vty0. Are you sure?[Y/N]y 

After the above configuration, when a user logs onto the device through VTY 0, the device automatically 

executes the configured command and logs off the current user. 

databits { 5 | 6 | 7 | 8 } 

AUX interface view 

2: System level 

5: Five data bits. 

6: Six data bits. 

7: Seven data bits. 

8: Eight data bits. 

Use the databits command to set the databits for the user interface. 

Use the undo databits command to revert to the default data bits. 

The default data bits is 8.