Инструкция С Настройками для ONKYO ht-s680

32

Press the [STANDBY/ON] button. 
Alternatively, press the remote controller’s [RECEIVER] button followed 
by the [ON] button.
The AV receiver comes on, the display lights up, and the STANDBY indicator goes off.

To turn the AV receiver off, press the [STANDBY/ON] button, or the remote control-
ler’s [STANDBY] button. The AV receiver will enter Standby mode. To prevent any 
loud surprises the next time you turn on the AV receiver, always turn down the volume 
before turning it off.

To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver before you use it for the 
very first time. These settings only need to be made once.

■ Have you connected a component to a digital audio input?

If you have, see “Assigning Digital Inputs to Input Sources” on 
page 33.

■ Have you connected an Onkyo MD recorder or CD recorder 

to the TAPE IN/OUT jacks?
If you have, see “Changing the TAPE/MD/CDR Display” on 
page 33.

CD recorder / MD recorder

TESTING THE  SPEAKERS
To test that all of the speakers are working properly, press the remote controller’s [TEST TONE] button. The test 
tone will be output by each speaker in turn and the name of each speaker will appear on the display. To turn off the 
test tone, press the [TEST TONE] button again.
• If the test tone is not produced by a speaker, or it’s produced by a speaker other than that shown on the display, 

you may have wired the speakers incorrectly and you should check your connections (see page 18).