Справочник Пользователя для Cisco 2600 Enterprise Plus Feature Pack CD26-AP-12.0.7=

Release Notes for Cisco IOS Release 12.0(7)XK1 Feature Packs for Cisco 2600 Series Routers  23

Enter yes in response to the prompt asking if you want to erase the existing image copy
resident in the router Flash memory before copying the new one.

Erase flash device before writing? [confirm] yes

The entire copying process takes several minutes and differs from network to network.

The exclamation point (!) indicates that the copy process is taking place. Each
exclamation point (!) indicates that ten packets have been transferred successfully. A
checksum verification of the image occurs after the image is written to Flash memory.

Enter the following commands to reset the configuration register to 0x2102.

Router(boot)(config)# config terminal

Router(boot)(config)# config-reg 0x2102

Router(boot)(config)# end

Enter the reload command to reload the router:

Router# reload

After reload is complete, the router should be running the required Cisco IOS image. Use the
show version command to verify.

This section describes documentation related to the Cisco 2600 series, typically including hardware
installation guides, software installation guides, Cisco IOS configuration and command references,
system error messages, and feature modules that are updates to the Cisco IOS documentation set.
Documentation is available as printed manuals or electronic documents, except for the feature
modules, which are available online only.

The most up-to-date documentation can be found on the Web via Cisco Connection Online (CCO)
and on the latest Documentation CD-ROM. These electronic documents might contain updates and
modifications made after the paper documents were printed. See the “Obtaining Documentation”
section on page 29 for more information.

This section contains the following subsections:

•

•

•

•