Инструкция для Sony SU-WL700

7 

(GB)

3

When using an electric screwdriver, set the torque setting to 
approximately 1.5 N·m {15 kgf·cm}.

4

Attach the Joint Bracket C to the Base 
Bracket AB securely.

Use four screws H (+BVST4 × 8).

Use four or more screws of 8 mm (

11

/

32

 inches) 

diameter or equivalent (not supplied).

~

• Be sure to align the assembled Base Bracket so that it is 

level.

If the Display has the Table-Top Stand attached, it 
should be removed before carrying out the procedure 
below. Refer to the operating instructions supplied with 
your Display.

~

• When removing the Table-Top Stand from the Display, lay 

the display face down on a stable work surface that is larger 
than the Display. 

• To prevent damaging the surface of the LCD display, make 

sure to place a soft cloth on the work surface.

• When lifting or moving the Display, keep a soft cloth 

underneath to prevent damage.

• The number and position of the screws on the rear of the 

Display differs, depending on the model of Display; be sure 
to read the operating instructions of your Display.

• If pressure or shock is applied to the surface of the Display, 

the LCD display may break or become damaged.

• Lay the display face down on a stable and level surface with 

the Table-Top Stand hanging over the edge of the surface. 
Having the display face and the base of the Table-Top Stand 
on the same level surface will create an unstable working 
condition and can damage the Display.

• When detaching the Table-Top Stand from the Display, 

hold the Table-Top Stand securely with both hands.

1

Remove the four screws from the rear of the 
Display.

2

Place the Washer Spacers (supplied with your 
Display) on the screw holes of the previous 
procedure.

Refer to the operating instructions supplied with your 
Display.

Attach the Mounting Bracket DE to the rear 
of the Display temporarily.

Temporarily tighten the top of the Mounting Bracket 
DE

 using two screws I (+PSW M6 × 16).

Attach the Lock Bracket F to the bottom of 
the Mounting Bracket DE.

1

Temporarily move the bottom of the Mounting 
Bracket DE outwards.

~

• If the bottom of the Mounting Bracket does not move, 

loosen the screws (return to step 3).

2

Insert the pins of the Mounting Bracket DE 
through the holes of the Lock Bracket F. Return 
the Mounting Bracket DE to their original 
position to attach the Lock Bracket F.

When connecting the Speaker System to the 
Display, connections should be made before the 
following wall mounting procedure. Refer to the 
instruction manual supplied with your Speaker 
System and Display beforehand.

Secure the Mounting Bracket DE to the rear 
of the Display.

When using an electric screwdriver, set the torque 
setting to approximately 2 N·m {20 kgf·cm}.

1

Tighten the bottom of the Mounting Bracket DE 
using two screws I (+PSW M6 × 16).

2

Be sure that all screws are securely tightened with 
equal torque to the rear of the Display.

(Continued)