Руководство По Установке для KitchenAid 30-Inch 4-Element Electric Downdraft Slide-In Range
13
4. Drill two ¹⁄
8
" (3 mm) holes that correspond to the bracket
holes of the determined mounting method. See the following
illustrations.
Rear position
Front position
Diagonal (2 options)
5. Using the two #10 x 1
5
⁄
8
" (4.1 cm) Phillips-head screws
provided, mount anti-tip bracket to the wall or floor.
6. Move range close enough to opening to allow for final
electrical connections. Remove shipping base, cardboard
or hardboard from under range.
7. Move range into its final location, making sure rear leveling
leg slides into anti-tip bracket.
8. Move range forward onto shipping base, cardboard
or hardboard to continue installing the range, using
the following installation instructions.
Floor Mounting
Wall Mounting
2. Locate the blower location template in the Installation
Parts Kit.
3. If the countertop extends behind the opening, measure
the distance from the back edge of the cabinet cutout
to the wall.
A
A. Countertop Filler Depth
Position the Blower Location Template
1. Determine and mark the centerline on the floor of the cabinet
opening.
A
A. Centerline
4. Fold the top of the blower mounting/venting template
on the line that corresponds to the countertop depth
measured in Step 3.
NOTE: The template has lines every
1
/
4
" (6.4 mm) from the back
edge. If the distance measured in the previous step is 1
1
/
4
"
(32 mm), fold the template on the line labeled 1
1
/
4
" (32 mm).
If there is no countertop filler depth, fold the template at zero
depth.
Fold Here
Le montage du ventilateur doit être fait dans cette zone
RETIRER LE GABARIT AVANT DE FINALISER L'INSTALLATION
GABARIT D'INSTALLATION D'UN SYSTÈME DE VENTILATION À ASPIRATION DESCENDANTE
Numéro de la pièce W10765779B
© 2015. Tous droits réservés.
No Rear
Countertop
Filler Fold Here
Pas de
bouche-fente pour
comptoir arrière pour
replier ici
Fold On Line Based On
Countertop Filler Depth
Measurement
Replier sur la ligne en
fonction de la mesure de
profondeur du bouche-fente
pour comptoir
Le montage du ventilateur doit être fait dans cette zone
Part Number W10765779B
© 2015. All rights reserved.