Руководство По Установке для KitchenAid 30-Inch 4-Element Electric Downdraft Slide-In Range

5.   Align the template centerline with the centerline marked  

on the floor. Align the folded edge of the template against 

the rear wall. 

 

NOTE: Secure the template to the floor with tape.

Determine which venting method to use: floor or rear wall  

venting. Go to the section for your type of venting. Consider  

the location of all utilities and ducts prior to determining final 

position to ensure proper fit and location.

1.   Determine where within area illustrated below the vent will 

exit. Mark the vent hole for the type of venting you are using.

 IMPORTANT:
 

■

 Check for obstructions (plumbing, electrical, wall studs, 

etc.) before marking the vent hole location.

 

■

 

The home venting system should terminate within  

the defined area using 5" (12.7 cm) round venting.

2.  Draw an outline of the vent on the wall and cut the vent hole.

13.  Go to the “Make Gas Connection” section.

A

C

D

B

A

  3. Locate the blower.
  4. Locate the blower outlet adapter in the installation parts kit.
  5.  Install the blower outlet adapter to the blower vent using 

three 8-18 x ³⁄

8

" screws. Seal the connection with aluminum 

foil tape.

  6. Remove three felt pads from the gasket strip.
  7.  Remove the paper backing from the felt pads and apply  

to the bottom of blower motor tabs.

      

 NOTE: Felt pads reduce motor noise and aid in mounting  

to uneven floors.

  8.  Position the blower on the template so that the blower  

outlet adapter aligns with the home venting.

       IMPORTANT: Make sure the blower motor is positioned 

within the area as shown on the template.

  9.  Connect the home vent system to the blower outlet  

adapter using sheet metal screws. Seal the connection  

with aluminum foil tape.

10.  Drill three ¹⁄

8

" (3 mm) pilot holes using the holes in the 

blower motor tabs as guides.

11. Remove the template.
12.  Mount the blower motor to the floor with three #10 x 1" 

screws provided.