Руководство По Установке для KitchenAid 30-Inch 4-Burner Dual Fuel Downdraft Slide-In Range

1.   Locate blower motor cover.
2.  Run the blower motor wires with strain relief through  

the small opening in the blower motor cover, starting from 

the inside and feeding out.

3.   Feed blower motor wire through opening and place the 

strain relief bracket to the inside of the blower cover. Install 

and tighten the two (2) provided #8–18 x 

3

⁄

8

" screws to  

secure the strain relief bracket.

4.  Reposition the blower motor cover retainer spring  

as illustrated.

5.  Remove paper from the rear of the rectangular felt pad  

and apply adhesive side of felt to the bellow flange.

 

 NOTE:  This step is important to ensure maximum blower 

performance.

  7.  Rotate blower motor cover so the bellows are facing  

towards the front of the installation.

  8.  Move blower motor wire to the front of the installation.
  9. Remove the cardboard or hardboard from under the range.
10.  Remove the front lower access panel of the range by gently 

lifting on the panel then pull outward.

11.  Using 2 or more people, gently move the range into its final 

location.

12.  Check to ensure the flexible metal gas connector and  

electrical cord are not kinked. Use a flashlight to look  

underneath the bottom of and behind the range.

13.  Verify that the anti-tip bracket is installed and engaged.
  

a.  Use a flashlight to look underneath the bottom  

of and behind the range.

  

b.  Visually check that the rear range foot is inserted  

into the slot of the anti-tip bracket.

14.  Rotate blower motor cover so the bellows are in their final 

position. Ensure the rear of the bellow flange is engaged  

in the retaining bracket.

6.  Apply blower motor cover to the blower. Slightly spread the 

cover retainer spring to allow the cover to drop into position 

on the blower motor.

 

 NOTE:  The blower motor cover will not properly install  

if the motor wire is on the top of the motor. 

Incorrect

Correct

15.  Secure the front of the blower bellow flange to the range 

frame with the supplied #8–18 x 

3

⁄

8

" screw.