Инструкция для Canon imagePROGRAF iPF6400SE

Cause

Corrective Action

The Platen has become dirty after bor-
derless printing or printing on small pa-
per.

Open the Top Cover and clean the Platen.

The type of paper as specified on the
printer does not match the type specified
in the printer driver.

Make sure the same type of paper is specified on the printer as in the printer driver.

Make sure the same paper type is specified in the printer driver as on the printer.

Press the Stop button and stop printing.

Change the type of paper in the printer driver and try printing again.

The paper is wrinkled or warped.

Straighten out the wrinkles or curls and reload the paper. Do not use paper that has been
printed on previously.

A cut line is printed because CutDus-
tReduct. is On in the Control Panel
menu to reduce cutting dust.

If this function is not needed, set CutDustReduct. to Off in the Control Panel menu.

The Printhead is set too low in the Con-
trol Panel menu.

In the Control Panel menu, set Head Height to Automatic.

You are printing on heavyweight paper
or paper that curls or wrinkles easily af-
ter absorbing ink.

For paper-based media such as Heavyweight Coated Paper, set the VacuumStrngth to
Strong or Strongest in the Control Panel menu. If the paper still rubs against the printhead,
set the Head Height in the Control Panel menu to a higher value than the current setting.

For film-based media such as Tracing Paper, set the VacuumStrngth to Standard, Strong
or Strongest in the Control Panel menu. If the paper still rubs against the printhead, set the
Head Height in the Control Panel menu to a higher value than the current setting.

The Ejection Guide is soiled.

Clean the Ejection Guide.

Cause

Corrective Action

The Paper Retainer is soiled.

Clean the Paper Retainer.

You are using a paper that does
not dry easily.

In the Control Panel menu, set Roll DryingTime to at least 1 min.

When paper that does not dry easily is used for printing, it may curl during printing and touch the
Output Tray.
In this case, in the Control Panel menu, complete the settings for Dry time and Area in Scan Wait
Time.
However, note that printing will now take longer.

Cause

Corrective Action

The Platen has become dirty after borderless printing or printing on
small paper.

Open the Top Cover and clean the Platen.

The Platen suction is too strong.

In the Control Panel menu, reduce the level of VacuumStrngth.

iPF6400SE

                                                                                                                                                                              

The edges of the paper are dirty

                                                                                                                                                                                                                             

Troubleshooting

Problems with the printing quality

623