Инструкция для Canon imagePROGRAF iPF850 MFP M40
Cannot print over a network
Cannot print over a network
Cannot connect the printer to the network
Cannot connect the printer to the network
Cause
Corrective Action
The Ethernet cable
is not connected
correctly to the
printer's Ethernet
port.
is not connected
correctly to the
printer's Ethernet
port.
1.
Make sure the printer is connected to the network with the correct Ethernet cable, and then turn the printer
on. For instructions on connecting the cable, refer to the Setup Guide.
on. For instructions on connecting the cable, refer to the Setup Guide.
2.
Make sure the Link indicator is lit.
The top indicator is lit in green and the bottom indicator is lit in orange when the printer is connected via
1000Base-T.
The top indicator is lit in green when the printer is connected via 100Base-TX.
The bottom indicator is lit in orange when the printer is connected via 10Base-T.
If the Link indicator is not lit, check the following points.
The top indicator is lit in green and the bottom indicator is lit in orange when the printer is connected via
1000Base-T.
The top indicator is lit in green when the printer is connected via 100Base-TX.
The bottom indicator is lit in orange when the printer is connected via 10Base-T.
If the Link indicator is not lit, check the following points.
•
Make sure the connection point is on.
•
Make sure the end of the Ethernet cable is connected correctly.
Insert the Ethernet cable until it clicks and locks in place.
Insert the Ethernet cable until it clicks and locks in place.
•
Make sure there is no problem with the Ethernet cable.
If there is any problem, replace the Ethernet cable.
If there is any problem, replace the Ethernet cable.
•
Check the communication mode with the connection point.
Although the printer normally detects the communication mode and transmission rate of the communi-
cation point automatically (in auto negotiation mode), sometimes the communication point settings
cannot be detected. In this case, configure the connection method manually, specifying the communi-
cation mode in use.
(See "
Although the printer normally detects the communication mode and transmission rate of the communi-
cation point automatically (in auto negotiation mode), sometimes the communication point settings
cannot be detected. In this case, configure the connection method manually, specifying the communi-
cation mode in use.
(See "
Cannot print over a TCP/IP network
Cannot print over a TCP/IP network
Cause
Corrective Action
The printer's IP address is not config-
ured correctly.
ured correctly.
Make sure the printer's IP address is configured correctly.
(See "
(See "
The printer's TCP/IP network settings
are not configured correctly.
are not configured correctly.
Make sure the printer's TCP/IP network settings are configured correctly.
(See "
(See "
The computer you are trying to print
from is not configured correctly.
from is not configured correctly.
Make sure the computer's TCP/IP network settings are configured correctly.
(See "
(See "
Cannot print over a Bonjour network
Cannot print over a Bonjour network
Cause
Corrective Action
The computer you are trying to
print from is not configured cor-
rectly.
print from is not configured cor-
rectly.
Make sure the computer is configured correctly.
(See "
(See "
The computer and printer are not
on the same network.
on the same network.
Due to the nature of Bonjour, you cannot print if the printer is on another network behind a rout-
er. Make sure the computer and printer are on the same network. For information about net-
work settings, ask your network administrator.
er. Make sure the computer and printer are on the same network. For information about net-
work settings, ask your network administrator.
Cannot connect the printer to the network
iPF850
Troubleshooting
Cannot print over a network
642