Инструкция для Canon imagePROGRAF iPF830

 

Grasp the Stacker outer frame (a) and push the
Stacker straight until the Ejection Support (b)
touches the end of the Output Stacker.

 

Lift up the Ejection Guide (b) until the Ejection Sup-
port (a) tip is at a higher position than the Output
Stacker tip, and then lower it again.
The Ejection Support is moved in front of the Out-
put Stacker tip.

This completes the preparation for ejecting to the
output stacker. Start printing.

Important

When lifting up the Ejection Guide, lift it up slowly. If you lift it up too vigorously, the Ejection Guide may
strike the Top Cover, damaging the printer.

Do not leave printed documents in the stacker for a long period of time. This may cause uneven colors
of the printed documents, etc.

Close the Output Stacker when you are not using the Output Stacker. If you install it on the Stacker
while the Output Stacker is open, the Output Stacker will touch the printer and may cause damage.

Depending on the type of paper, the edge may curl or bend during ejection. In this case, straighten out
the paper. If the paper is curled or bent, it may damage printed documents.

Store the Output Stacker when printing long documents such as banners. It is recommended that you
spread a clean cloth or paper on the floor and select Eject as the method for cutting roll paper to pre-
vent that printing from becoming soiled or scratched. 

 (See "Specifying the Cutting Method for

Rolls.")

➔

a

b

 

a

b

 

Ejecting to the Output Stacker

                                                                                                                                                                     

iPF850 Series

                                                                                                                                                                                                                      

Handling Paper

Stacker

 

36