Справочник Пользователя для Netgear XAVNB2001 – Powerline AV 200 Wireless-N Extender Kit

Connect a computer to the Powerline 

Extender for initial setup.
Use the supplied Ethernet cable to connect 

the Powerline Extender to an Ethernet port 

on a computer. 
The Powerline devices attempt to detect 

each other and form a Powerline network. 

This could take a few minutes.

Plug any additional Powerline devices you 

are using into power outlets near the other 

computers and devices to be included in 

your Powerline network. 

Wait for each Powerline adapter or extender 

to be recognized by the Powerline network. 
The Power, Ethernet, and Powerline LEDs should turn on. This could take as little as 5 

seconds, or up to 80 seconds. If the Powerline LEDs are green or amber, the devices are 

successfully connected. A red LED indicates a weak link rate. In this case, move the 

adapter or the extender to another electrical outlet with a better connection. 

Set up the Powerline Extender wireless network as explained in 

10.

Add the Powerline Extender to an Existing Powerline Network

Your existing Powerline network needs to have two or more compatible Powerline devices 

that communicate with each other. (models XAV101, XAV1004, XAV2001, XAV2501, and 

XAVN2001). One of these Powerline devices has to be cabled with Ethernet to your router so 

that the Powerline network is linked to your local area network (LAN). 



If you used the Security buttons or the Powerline Utility to secure your Powerline 

network, press the Reset button on each Powerline device to return it to its factory 

settings.
This is the quickest way to allow your new Powerline AV 200 Wireless-N Extender to 

communicate with the other Powerline devices.