Справочник Пользователя для Netgear XAVNB2001 – Powerline AV 200 Wireless-N Extender Kit

Connect a computer to the Powerline 

Extender for initial setup.
Use the supplied Ethernet cable to connect 

the Powerline Extender to an Ethernet port 

on a computer.

For convenience during setup, plug the 

Powerline Extender into an electrical outlet 

near your router. 
The Powerline Extender attempts to detect 

the other compatible Powerline devices in 

your network and join the Powerline 

network. This could take a few minutes.

Check the Powerline LEDs to make sure 

that the Powerline devices are 

communicating with each other. If the LEDs are green or amber, the devices are 

successfully connected. A red LED indicates a weak link rate. In this case, move the adapter 

or the extender to another electrical outlet with a better connection.

Set up the Powerline Extender wireless network as explained in 

Set Up the Extender Wireless Network

You need to set up the extender so that it can join your wireless network. To do this you can 

use either the Powerline Utility or Wi-Fi Protected Setup (WPS).

If your router does not have WPS, or you are not sure, use Method A.

If your router does have WPS, use Method B.

Method A: Use the Powerline Utility for Wireless Setup



On the computer that is cabled to the Powerline Extender (XAVN2001), insert the 
Resource CD

, and install the Powerline Utility. 

Follow the onscreen prompts:

If you have a NETGEAR router, the Utility automatically finds the router, retrieves the 

wireless settings, and then prompts you to confirm the settings. 

If the router is not a NETGEAR router, or the NETGEAR router is not detected, 

manually enter the wireless settings. 

Disconnect the Ethernet cable from the Powerline Extender (XAVN2001). 

Move the Powerline Extender to the area (or dead zone), where you want to extend wireless 

coverage, and plug it into an electrical outlet.