Использование И Уход для KitchenAid 19 Cu. Ft. Standard-Depth Bottom-Freezer Refrigerator, Architect® Series II

Door Closing and Door Alignment

The base grille covers the leveling screws and roller assemblies 
located at the bottom of the refrigerator cabinet below the freezer 
door or drawer. Before making adjustments, remove the base 
grille and move the refrigerator to its final location. 
1. Remove the two screws fastening the base grille to the 

cabinet, and set the screws aside. Grasp the grille and pull it 
toward you.  

2. Move the refrigerator to its final location.

NOTE: To allow the refrigerator to roll easier, raise the leveling 
legs off the floor by turning the leveling screws 
counterclockwise. The front rollers will be touching the floor. 

3. So the doors will close easier, use a 

¹⁄₄" hex driver to turn both 

leveling screws clockwise. This will raise the front of the 
refrigerator tilting it slightly downward to the rear. Turn both 
leveling screws the same amount.
NOTE: Having someone push against the top of the 
refrigerator takes some weight off the leveling screws. This 
makes it easier to turn the screws.    

4. Open and close the doors to make sure they close as easily as 

you like. If not, increase the tilt by turning both leveling screws 
clockwise. It may take several turns of the leveling screw to 
allow the doors to close easier.

5. Check for door alignment. If one door is lower than the other, 

adjust the leveling screw, on the lower side of the refrigerator. 
Using a 

¹⁄₄" hex driver, turn the screw clockwise to raise that 

side of the refrigerator until the doors are aligned. It may take 
several turns of the leveling screw to raise the refrigerator.

NOTE: Having someone push against the top of the 
refrigerator takes some weight off the leveling screws. This 
makes it easier to turn the screws. 

6. Make sure the refrigerator is steady. If the refrigerator seems 

unsteady or rolls forward when the door or drawer is opened 
adjust the leveling screws. Using a 

¹⁄₄" hex driver, turn the 

leveling screw on each side clockwise until the rollers are up 
and the leveling feet are firmly against the floor. 

7. Replace the base grille by aligning the holes in the grille with 

the holes in the cabinet and fasten using the screws removed 
in Step 1.

REFRIGERATOR USE

Using the Controls

Your model may have Electronic Controls or Digital Controls. 
IMPORTANT: 

■

Wait 24 hours for your refrigerator to cool completely before 
adding food. If you add food before the refrigerator has cooled 
completely, your food may spoil.

NOTE: Adjusting the Refrigerator and Freezer Controls to a 
higher (colder) than recommended setting will not cool the 
compartments any faster. 

■

The recommended settings should be correct for normal 
household refrigerator use. The controls are set correctly 
when milk or juice is as cold as you like and when ice cream is 
firm.

■

If the temperature is too warm or too cold in the refrigerator or 
freezer, first check the air vents to be sure they are not 
blocked before adjusting the controls.

A

B