Руководство По Установке для KitchenAid KXW9748YSS

1.  Slightly spread the sides of the cover apart and hook 

them behind the upper chimney.

2.  Secure the lower chimney covers to the range hood 

canopy using 4 - 4.2 x 8 mm screws.

Complete Installation and Check 

Operation

1.  Install grease filters. See “Range Hood Care” section.
2.  Check operation of the range hood blower and lights. 

See “Range Hood Use” section.

3.  If range hood does not operate, check to see whether 

a circuit breaker has tripped or a household fuse has 

blown. Disconnect power supply and check that the 

wiring is correct.

NOTE: To get the most efficient use from your new range hood, 

read the “Range Hood Use” section.

RANGE HOOD USE

The range hood is designed to remove smoke, cooking vapors 

and odors from the cooktop area. For best results, start the 

range hood before cooking and allow it to operate several 

minutes after the cooking is complete to clear all smoke and 

odors from the kitchen.
The range hood controls are located on the underside of the 

range hood.

Range Hood Controls

1.  Move the light switch to the “1” position to turn range hood 

light to night light setting.

2.  Move the light switch to the “2” position to turn range hood 

light to full light setting.

3.  Move the light switch to the “Off” position to turn range hood 

light Off.

1.  Move the fan switch to the “On” position to turn the fan 

On. The fan will begin operating at the speed set on the 

fan speed switch.

2.  Move the fan switch to the “Off” position to turn the fan Off.

The range hood is equipped with a sensor to automatically 

turn on the fan when excessive heat is detected in the control 

area. When the fan switch is in the “Off” position, this sensor 

will turn the fan to high speed when necessary. When the heat 

decreases, the fan will turn Off.
When the fan switch is in the “On” position, the heat sensor is 

not active and the range hood functions normally.

The fan has 3 speed controls. Move the fan speed switch to “1” 

position for low speed, “2” position for medium speed, or “3” 

position for high speed.

The range hood is equipped with a thermal protector to avoid 

overheating conditions. If the range hood shuts off while in use, 

move fan slider switch to “Off” to turn off the range hood. Wait 

approximately 60 minutes, then move slider to “On” to restart 

the range hood.