Руководство По Установке для KitchenAid KXW9748YSS

The heat lamps are designed to keep food warm prior to serving. 

The cooktop surface is too far away from the heat lamp to be 

used as a shelf.
For best results, install a metal shelf to hold the food closer 

to the lamps. The optimum distance between the shelf and 

the range hood is 12" (30.5 cm) to 15" (38.1 cm).

For best performance, food should be placed directly under 

the heat lamps, not between them. You may need to adjust 

your food placement to match your needs.
1.  Install heat lamp bulbs into heat lamp sockets.

NOTE: Heat lamp bulbs should be rated to a maximum of 

175 watts each. For best performance, 175 watt maximum, 

PAR38 type, red heat lamp bulbs are recommended. Bulb 

performance varies. Lower wattage and clear bulbs decrease 

the performance.

2.  To turn on the heat lamps, move the switch to the “I” 

position. To turn off the heat lamps, move the switch 

to the “O” position.

RANGE HOOD CARE

Cleaning

IMPORTANT: Clean the range hood and grease filters frequently 

according to the following instructions. Replace grease filters 

before operating range hood.

To avoid damage to the exterior surface, do not use steel wool 

or soap-filled scouring pads.
Always wipe dry to avoid water marks.
Cleaning Method:

 

■

Liquid detergent soap and water, or all-purpose cleanser

 

■

Wipe with damp soft cloth or nonabrasive sponge, and then 

rinse with clean water and wipe dry.

1.  Use 2 hands to remove the metal grease filters. Grasp filter 

handles, push toward the rear of the range hood and pull 

down on the front handle to remove.

2.  Repeat for each grease filter.
3.  Wash metal grease filters as needed in a dishwasher 

or hand wash in a hot detergent solution to clean.

1.  Grasp filter handles and place rear of filter into rear track.
2.  Push down on the rear handle and set the front of the 

grease filter into the front track to secure.

3.  Repeat for each filter.

This range hood uses two 175 watt maximum heat lamps.
Turn off the heat lamps and allow them to cool.

1.  Disconnect power.
2.  Remove the heat lamp bulb from its socket.
3.  Replace the heat lamp bulb with the same type bulb and 

tighten it in its socket.

4.  Repeat steps 2 and 3 with the other heat lamp bulb if 

necessary.

5.  Reconnect the power.

Turn off the range hood and allow the halogen lamp to cool. 

To avoid damage or decreasing the life of the new lamp, do 

not touch lamp with bare fingers. Replace lamp, using tissue 

or wearing cotton gloves to handle lamp.
If new lamps do not operate, make sure the lamps are inserted 

correctly before calling service.
1.  Disconnect power.
2.  Push up on the lens and turn it counterclockwise.

3.  Remove the lamp and replace it with a 120-volt, 50-watt 

maximum halogen lamp with a GU10 base. Turn it clockwise 

to lock it into place.

4.  Repeat steps 2-3 for the other lamp if needed.
5.  Reconnect power.