Использование И Уход для KitchenAid KXW9748YSS

5.  Attach power supply connector from the range hood 

to the connector on the blower motor assembly.

6.  Reinstall the heat lamp panel using the screws removed in 

the “Preparing the Internal Blower System,” (2) in the sides 

and either (3) in the back for the 36" (91.4 cm) model or (4) 

in the back for the 48" (121.9 cm) model.

7.  Reconnect the electrical connector to the heat lamp.
8.  Go to the “Make Electric Power Supply Connection 

to Range Hood” section.

Install Range Hood In-Line (External Type) 

Blower Motor

NOTE: Your range hood requires you to purchase an in-line 

(external type) blower motor system. See “Blower Motor 

System” in the “Accessories” section.

The in-line blower system must be fastened to a secure 

structure of the roof, ceiling, wall, floor, or new or existing 

frame construction. The 4 holes on either the inlet (bottom) 

side or the outlet (top) side of the blower must be used to 

mount the in-line blower system to the structure.
NOTE: The mounting hole locations must span the studs. 

Additional stud framing may be required. Plywood may 

be used to span open areas between ceiling joists or roof 

rafters to aid installation. This structure must be strong 

enough to support the weight of the in-line blower system 

(50 lb [22.6 kg] min).

1.  Using 2 or more people, move the in-line blower 

motor system to the mounting location.

2.  Remove the 10 screws from the front cover of the  

in-line blower motor housing and set them aside.

3.  Remove the front cover of the in-line blower motor 

housing and set it aside.
NOTE: To make the blower motor housing easier to 

mount, the blower motor assembly can be removed. 

If you do not want to remove the blower motor 

assembly, proceed to “Install In-line Blower System” 

in this section.

4.  Disconnect the motor electrical plug from the blower 

motor assembly.

5.  Remove the screws that secure the blower motor 

assembly to the in-line blower housing and set them aside.

6.  Pull the spring clip to release the blower motor assembly. 

Remove the blower motor assembly from the housing and 

place it on a covered surface.

A

B

A