Использование И Уход для KitchenAid KXW9748YSS

NOTE: The blower motor housing can be mounted using 4 holes 

from either the outlet side or the inlet side of the blower.

1.  Position the in-line blower motor housing in its mounting 

location, and mark the 4 mounting hole locations.

2.  Drill 4 mounting pilot holes using a 

3

/

16

" (4.8 mm) drill bit.

3.  Attach the in-line blower motor housing to the mounting 

location with four 6 x 80 mm mounting screws and washers.

4.  If it is removed, reinstall the blower motor assembly and 

secure it with the screws previously removed.

5.  If it is removed, reattach the motor electrical plug to the 

connector on the blower motor assembly.

1.  Determine and make all necessary cuts for the vent system.

IMPORTANT: When cutting or drilling into the ceiling or wall, 

do not damage electrical wiring or other hidden utilities

2.  Determine the location where the 

1

/

2

" (1.3 cm) wiring conduit 

will be routed through the ceiling or wall between the in-line 

blower and the range hood.

3.  Drill a 1

1

/

4

" (3.2 cm) hole at this location.

4.  Locate the electrical terminal boxes in the in-line blower 

housing and range hood. Remove the terminal box covers 

and set the covers and screws aside.

5.  Remove the electrical knockout from the in-line blower 

housing and range hood to prepare for the installation of 

the UL listed or CSA approved 

1

/

2

" (1.3 cm) wiring conduit 

and conduit connector.

6.  With the range hood mounted (see the “Install Range 

Hood” section), run the 

1

/

2

" (1.3 cm) wiring conduit 

between the in-line blower motor housing and the range 

hood. Pull enough 

1

/

2

" (1.3 cm) wiring conduit to allow for 

easy connection to the terminal boxes in the in-line blower 

housing and range hood.

7.  Run the six 18 AWG wires through the 

1

/

2

" (1.3 cm) wiring 

conduit and conduit connectors and into the terminal 

boxes on the in-line blower housing and range hood. 

Leave enough wire length in each terminal box to make 

the wiring connections.

8.  Install the conduit connectors and conduit to the in-line 

blower housing and range hood electrical terminal boxes.

9.  Connect the vent system to the range hood and in-line 

blower system, and seal all joints with clamps.

Make Electrical Connections for In-Line 

Blower Motor System

1.  Disconnect power.