Использование И Уход для KitchenAid KXW9748YSS

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting 

installation. Read and follow the instructions provided 

with any tools listed here.

 

■

Level

 

■

Drill

 

■

Drill 1

1

/

4

" (3 cm) drill bit

 

■

3

/

32

" (2.4 mm) drill bit if installing into wood

 

■

Pencil

 

■

Wire stripper or utility knife

 

■

Tape measure or ruler

 

■

Pliers

 

■

Caulking gun and weatherproof caulking compound

 

■

Vent clamps

 

■

Jigsaw or keyhole saw

 

■

Flat-blade screwdriver

 

■

Metal snips

 

■

Phillips screwdriver

 

■

Scissors

 

■

Home power supply cable

 

■

1 - 

1

/

2

" (12.7 mm) UL listed or CSA approved strain relief

 

■

3 UL listed wire connectors

 

■

1 wall or roof cap

 

■

Metal vent system

 

■

2 - 175-watt max heat lamp bulbs

 

■

Blower motor system - internal or external (see “Blower 

Motor System” in the “Accessories” section).

Remove parts from packages. Check that all parts are included.

 

■

2 metal grease filters for 36" (91.4 cm) models 

3 metal grease filters for 48" (121.9 cm) models

 

■

Damper

 

■

2 - Vent cover support brackets

 

■

2 - 10 x 50 mm wall anchor

 

■

2 - 8 x 40 mm wall anchor

 

■

2 - D5.3 x 20 mm washers

 

■

4 - 5 x 45 mm screws

 

■

9 - 4.2 x 8 mm screws

 

■

T20

®

 TORX

®†

 adapter

Location Requirements

IMPORTANT: Observe all governing codes and ordinances.
Have a qualified technician install the range hood. It is the 

installer’s responsibility to comply with installation clearances 

specified on the model/serial/rating plate. The model/serial/

rating plate is located inside the range hood on the rear wall 

of the range hood.
This range hood is recommended for use with cooktops 

with a maximum total rating of 105,000 BTUs or less.
Canopy range hood location should be away from strong draft 

areas, such as windows, doors and strong heating vents. 
Cabinet opening dimensions that are shown must be used. 

Given dimensions provide minimum clearance.
The canopy range hood is factory set for venting through 

the roof or through the wall.
All openings in ceiling and wall where canopy range hood 

will be installed must be sealed.

The installation of this range hood must conform to the 

Manufactured Home Construction Safety Standards, Title 24 

CFR, Part 328 (formerly the Federal Standard for Mobile Home 

Construction and Safety, Title 24, HUD, Part 280) or when 

such standard is not applicable, the standard for Manufactured 

Home Installation 1982 (Manufactured Home Sites, Communities 

and Setups) ANSI A225.1/NFPA 501A, or latest edition, or with 

local codes.

†

®

TORX and T20 are registered trademarks of Acument Intellectual Properties, LLC.