Руководство По Установке для Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP)

Installing and Operating UBIC-V EIAs in the Cisco ONS 15454

78-16140-04

Remove and Replace UBIC-V Cables

Figure 14

Removing a UBIC-V EIA Cable

Step 2

Use the flathead screwdriver to loosen and remove the screws attached to the top left and bottom right
of the SCSI connector.

Step 3

Pull the connector away from the UBIC-V at a downward angle, being careful to avoid other installed
cables.

Step 4

To replace a UBIC-V cable with a new one, gently hold back any cables from adjacent connectors.

Step 5

Carefully maneuver the new cable connector between installed cables and put the cable connector of the
new cable over the desired connection point on the backplane.

Step 6

Gently push the connector into the backplane until the notch backplane connector slides into the slot on
the cable connector.

Step 7

Use the flathead screwdriver to tighten the screw at the top left of the cable connector two to three turns.
Repeat this for the screw at the bottom right of the connector. Alternate between the two screws until
both are tight.

115 139