Руководство По Установке для Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP)
18
Installing and Operating UBIC-V EIAs in the Cisco ONS 15454
78-16140-04
Install the Standoffs and Rear Cover
Install the Standoffs and Rear Cover
For instructions about installing the standoffs and rear cover, refer to the Installing Rear Standoffs and
Mounting Bars from the Cisco ONS 15454 Shelf Accessory Kit (78-16607-XX) document.
Mounting Bars from the Cisco ONS 15454 Shelf Accessory Kit (78-16607-XX) document.
Remove and Replace UBIC-V Cables
If you are removing a connector pair, remove the transmit (Tx) cable and then the receive (Rx) cable.
You will need a 3/16-inch flathead screwdriver for this procedure.
You will need a 3/16-inch flathead screwdriver for this procedure.
Note
If necessary and approved by local site practice, you can cut and remove cable bundling material such
as tie wraps or lacing to make it easier to remove UBIC-V cables.
as tie wraps or lacing to make it easier to remove UBIC-V cables.
Step 1
To remove a UBIC-V cable, gently hold back cables from any adjacent connectors (