Руководство По Обслуживанию для Cisco Cisco Unified MeetingPlace Audio Server
February 27, 2004
Cisco MeetingPlace Audio Server System Manager’s Guide
1
Introduction
Welcome to Cisco MeetingPlace
®
. With Cisco MeetingPlace, users in
different locations can collaborate in real time by sharing documents over
their computers and discuss content over the telephone. Because Cisco
MeetingPlace integrates with common interfaces, such as groupware clients,
web browsers, and standard and IP-based telephones, users can quickly
schedule and attend conferences using their preferred interface from any
location.
their computers and discuss content over the telephone. Because Cisco
MeetingPlace integrates with common interfaces, such as groupware clients,
web browsers, and standard and IP-based telephones, users can quickly
schedule and attend conferences using their preferred interface from any
location.
This guide describes how to set up and maintain Cisco MeetingPlace after
your 8112 (formerly called “M3”) or 8106 system has been installed. (For
information on preparing to install Cisco MeetingPlace, see the Cisco
MeetingPlace Audio Server 5.2 Installation Planning Guide. For information
on installing Cisco MeetingPlace, see your Cisco MeetingPlace support
representative.)
your 8112 (formerly called “M3”) or 8106 system has been installed. (For
information on preparing to install Cisco MeetingPlace, see the Cisco
MeetingPlace Audio Server 5.2 Installation Planning Guide. For information
on installing Cisco MeetingPlace, see your Cisco MeetingPlace support
representative.)
This chapter discusses the following topics:
•
•
•
•
•
•
•
I
MPORTANT
FOR
8112
CUSTOMERS
The tape drive on the Cisco
MeetingPlace 8112 server has been replaced with a CD-ROM drive. The
CD-ROM drive is used for upgrading from previous software releases.
Instructions for retrofitting the CD-ROM is included in the upgrade kit. Please
note the following:
CD-ROM drive is used for upgrading from previous software releases.
Instructions for retrofitting the CD-ROM is included in the upgrade kit. Please
note the following:
•
Customers with 8112 units with the tape drive installed will need to have a
CD-ROM retrofitted on their system before they can upgrade to
Release 5.2.
CD-ROM retrofitted on their system before they can upgrade to
Release 5.2.
•
Customers with 8112 units loaded with Release 5.2 fresh from the factory
will receive their units with the CD-ROM already installed. These
customers do not need to do anything.
will receive their units with the CD-ROM already installed. These
customers do not need to do anything.
•
Customers with tape drives who are upgrading to Release 5.2 will be
contacted by Cisco Technical Support about having the CD-ROM retrofit
done.
contacted by Cisco Technical Support about having the CD-ROM retrofit
done.
•
Customers not previously contacted should call Cisco Technical Support
to arrange to have their retrofit done. Customers should not attempt to do
the retrofit by themselves, even if they have the CD-ROM retrofit kit.
to arrange to have their retrofit done. Customers should not attempt to do
the retrofit by themselves, even if they have the CD-ROM retrofit kit.