Cisco Cisco Unified MeetingPlace Audio Server 维护手册

Welcome to Cisco MeetingPlace

®

. With Cisco MeetingPlace, users in 

different locations can collaborate in real time by sharing documents over 
their computers and discuss content over the telephone. Because Cisco 
MeetingPlace integrates with common interfaces, such as groupware clients, 
web browsers, and standard and IP-based telephones, users can quickly 
schedule and attend conferences using their preferred interface from any 
location.

This guide describes how to set up and maintain Cisco MeetingPlace after 
your 8112 (formerly called “M3”) or 8106 system has been installed. (For 
information on preparing to install Cisco MeetingPlace, see the Cisco 
MeetingPlace Audio Server 5.2 Installation Planning Guide. For information 
on installing Cisco MeetingPlace, see your Cisco MeetingPlace support 
representative.)

This chapter discusses the following topics:

•

•

•

•

•

•

•

The tape drive on the Cisco 

MeetingPlace 8112 server has been replaced with a CD-ROM drive. The 
CD-ROM drive is used for upgrading from previous software releases. 
Instructions for retrofitting the CD-ROM is included in the upgrade kit. Please 
note the following:

•

Customers with 8112 units with the tape drive installed will need to have a 
CD-ROM retrofitted on their system before they can upgrade to 
Release 5.2.

•

Customers with 8112 units loaded with Release 5.2 fresh from the factory 
will receive their units with the CD-ROM already installed. These 
customers do not need to do anything.

•

Customers with tape drives who are upgrading to Release 5.2 will be 
contacted by Cisco Technical Support about having the CD-ROM retrofit 
done.

•

Customers not previously contacted should call Cisco Technical Support 
to arrange to have their retrofit done. Customers should not attempt to do 
the retrofit by themselves, even if they have the CD-ROM retrofit kit.