Листовка для Cisco Cisco Wireless LAN Controller Module
VLANs on Wireless LAN Controllers Configuration
Example
Example
Document ID: 68100
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Dynamic Interfaces on WLCs
Configure
Catalyst Switch Configurations
WLAN Controller VLAN Configuration
Verify
Catalyst Switches Verification
WLAN Controller VLAN Verification
Troubleshoot
Troubleshooting Procedure
Related Information
Prerequisites
Requirements
Components Used
Conventions
Dynamic Interfaces on WLCs
Configure
Catalyst Switch Configurations
WLAN Controller VLAN Configuration
Verify
Catalyst Switches Verification
WLAN Controller VLAN Verification
Troubleshoot
Troubleshooting Procedure
Related Information
Introduction
This document describes how to configure VLANs on Wireless LAN controllers (WLCs).
Prerequisites
Requirements
There are no specific requirements for this document. However, this document assumes that there is a working
DHCP server to provide IP addresses to the access points (APs) that are registered to the controller.
DHCP server to provide IP addresses to the access points (APs) that are registered to the controller.
Components Used
The information in this document is based on these software and hardware versions:
Configuration A:
Catalyst switch that runs Cisco IOS
®
Software and a WLAN controller
♦
Cisco 4404 WLAN Controller that runs software version 7.0
♦
•
Configuration B:
Catalyst switch that runs Catalyst OS (CatOS) software and a WLAN controller
♦
Cisco 4404 WLAN Controller that runs software version 7.0
♦
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.