Листовка для Cisco Cisco Wireless LAN Controller Module
Note: Use the Command Lookup Tool (registered customers only) to find more information on the commands
used in this document.
used in this document.
Catalyst Switch Configurations
This section uses these configurations:
Catalyst Switch That Runs Cisco IOS Software
•
Catalyst Switch That Runs CatOS Software
•
Catalyst Switch That Runs Cisco IOS Software
lab1sup720ip1#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
lab1sup720ip1(config)#interface gigabitethernet 1/6
lab1sup720ip1(config−if)#
lab1sup720ip1(config−if)#switchport
lab1sup720ip1(config−if)#switchport trunk encapsulation dot1q
lab1sup720ip1(config−if)#switchport trunk allowed vlan 1,5,15,20,25,30,35,40,45,50,55,100
lab1sup720ip1(config−if)#switchport mode trunk
lab1sup720ip1(config−if)#end
lab1sup720ip1#
Catalyst Switch That Runs CatOS Software
controller−catos> (enable) set trunk 2/1 on dot1q
Port(s) 2/1 trunk mode set to on.
Port(s) 2/1 trunk type set to dot1q.
!
!clearing out/pruning unwanted vlans
!
controller−catos> (enable) clear trunk 2/1 21−24,26−30,31−34,36−39,41−44,46−49,51−54,
56−99,101−999
!−−− This command should be on one line.
Removing Vlan(s) 21−24,26−34,36−39,41−44,46−49,51−54,56−99,101−999 from allowed list.
Port 2/1 allowed vlans modified to 1,5,15,20,25,35,40,45,50,55,100,1000−1005,1025−4094.
WLAN Controller VLAN Configuration
GUI Configuration
Complete these steps on the WLAN controller.
From the WLC GUI, choose Controller > Interfaces. The Interfaces page lists all the interfaces that
are configured on the WLC. In order to create a new dynamic interface, click New.
are configured on the WLC. In order to create a new dynamic interface, click New.
1.