Краткое Руководство По Установке для Cisco Cisco Unified MeetingPlace for Microsoft Office Communicator
Configuring Reservationless Single Number Access (RSNA) for Cisco Unified MeetingPlace
How to Configure RSNA
5
Related Topics
•
in the
module
•
in the
module
•
What To Do Next
Proceed to the
.
How to Configure Call Control for RSNA in a Cisco Unified
Communications Manager Environment
Communications Manager Environment
Complete the following tasks, in the order shown, on each Cisco Unified Communications Manager
node that is attached to a Cisco Unified MeetingPlace RSNA system.
node that is attached to a Cisco Unified MeetingPlace RSNA system.
•
•
Configuring Cisco Unified Communications Manager: SIP Trunk to Remote RSNA System
In this task, you connect the local Cisco Unified Communications Manager to each remote
Cisco Unified MeetingPlace RSNA system.
Cisco Unified MeetingPlace RSNA system.
Before You Begin
•
Configure non-RSNA call-control for each Cisco Unified MeetingPlace system as described in the
module.
•
We recommend that you create a SIP trunk security profile in Cisco Unified
Communications Manager specifically for Cisco Unified MeetingPlace.
Communications Manager specifically for Cisco Unified MeetingPlace.
See
in the
module.
•
You perform this task in the Cisco Unified Communications Manager Administration pages.
Because the pages and menus vary by release, you should check the Cisco Unified
Communications Manager Administration online help for step-by-step instructions that are specific
to your release.
Because the pages and menus vary by release, you should check the Cisco Unified
Communications Manager Administration online help for step-by-step instructions that are specific
to your release.
Procedure
Step 1
Go to http://ccm-server/, where ccm-server is the fully-qualified domain name or IP address of the
Cisco Unified Communications Manager server.
Cisco Unified Communications Manager server.
Step 2
Log in with your Cisco Unified Communications Manager administrator username and password.
Step 3
Select Device > Trunk.
Step 4
Select Add New.