Руководство По Установке для Cisco Series 9900 RF Signal Manager Active Products (NTSC)
Chapter 2 Installing the Series 9900 Chassis in a Rack
34
591772 Rev G
1 Make sure that the site requirements are met as outlined in Before You Begin
(on page 24).
2 Insert the cable tie bases downwards into the holes in the cable tray assembly.
Then slide the cable ties through the two loops in each cable tie base.
3 Set the module chassis on top of the cable channels of the cable tray assembly as
shown.
4 Insert and tighten 4 screws that pass through the sides of the cable tray assembly
into threaded holes in the sides of the module chassis. Tighten the screws to 9 in-
lb (1.0 Nm).
Result: The module chassis is installed on the cable tray assembly.
Result: The module chassis is installed on the cable tray assembly.