Руководство По Установке для Cisco Series 9900 RF Signal Manager Active Products (NTSC)
Series 9900 Chassis Installation in a 19-Inch Relay Rack
591772 Rev G
35
5 Set cable tray/module chassis assembly on the angle support brackets, and align
the four slots in the bottom of the cable tray assembly with the mounting holes
on the angle support brackets.
6 Attach the cable tray assembly to the left and right angle support brackets with
four screws that pass vertically through slots in the cable tray and into the
threaded holes in the brackets. Tighten the screws to 9 in-lb (1.0 Nm).
Result: The cable tray/module chassis assembly is installed in the rack.
Result: The cable tray/module chassis assembly is installed in the rack.
7 Go to Chapter 3, Installing the Series 9900 Modules in the Chassis (on page 37).