для Cisco Cisco 1900 2900 3900 Series 4-Port Gigabit Ethernet HS-WIC with PoE

Скачать
Страница из 162
Configuring Cisco EHWIC and 880G for 3.7G (HSPA+)/3.5G (HSPA)
  Overview of the EHWIC-3G-HSPA-U Card
12
Configuring Cisco EHWIC-3G-HSPA-U
OL-24265-03
EHWIC-3G-HSPA-U supports the diversity (dual antenna) mode. The types of antennas include the 
swivel-mounted dipole with extended base and ceiling-mounted antennas. The diversity mode requires 
two antennas located together and spaced a minimum of 7.5 inches (19 cm) for better RF reception.
Note
By default, the diversity mode is enabled. However, it is disabled after GPS is turned on.
 describes the functions of the LEDs of EHWIC-3G-HSPA-U. The LEDs provide a visual 
indication of your available services.
For information on how to install the EHWIC-3G-HSPA-U card in supported Cisco Access Routers, see 
.
For information on how to connect the EHWIC-3G-HSPA-U card to your network, see 
Table 2
EHWIC-3G-HSPA-U LED Description
LED
Description
WWAN LED
Modem status and 
data transmission
Off: EHWIC in reset mode or not powered.
Slow Green Blink: Searching for service.
Solid Green: Active service; no traffic detected.
Fast Green Blink: Active service. Detected traffic is proportional to blink rate.
RSSI LED
Received Signal 
Strength Indicator
Off: Low RSSI (under -100 dBm).
Slow Green Blink: Low or medium RSSI (-99 to -90 dBm).
Fast Green Blink: Medium RSSI (-89 to -70 dBm).
Solid Green: High RSSI (-69 dBm or higher).
Solid Yellow: No service or no RSSI detected.
HSPA LED
3G-HSPA Service 
Indicator
Off: GPRS or EDGE Service.
Green Blink: UMTS Service.
Solid Green: HSPA Service.
GPS LED
GPS Acquisition
Off: Searching for signal or disabled.
Solid Green: Signal found.