Руководство По Установке для Cisco Cisco Agent Desktop 10.5
31-Mar-06
79
4. Open a command window and navigate to the VLANTest folder.
5. Determine the MAC address of the test target NIC by executing
ipconfig /all at the command prompt. Write down the number that appears
for the Physical Address. See
for the Physical Address. See
address of the Intel Pro/100” NIC card is 00-D0-59-d8-f7-d9.
Figure 1.
Output of the ipconfig /all command.
6. Determine the device interface number of the test target NIC. Execute
windump -D and write down the number of the NIC you want to test. In our
example, we are interested in the interface number 1 that corresponds to the
Intel Pro/100 NIC card.
example, we are interested in the interface number 1 that corresponds to the
Intel Pro/100 NIC card.
NOTE: If you are not sure which number to pick, repeat the test for each card
until the test succeeds for one (sufficient to pass) or this fails for all cards.
until the test succeeds for one (sufficient to pass) or this fails for all cards.
7. Start WinDump to monitor the test target NIC for incoming VLAN packets. To
do this, execute windump -i <device number> vlan. In the following
example, the device number is 1.
example, the device number is 1.