Руководство По Установке для Cisco Cisco TelePresence MX700
D14639.05 Video Systems Getting Started Guide (TC5.0) | 2011 NOVEMBER | © 2011 Cisco Systems, Inc. All rights reserved.
www.cisco.com
15
GettinG started Guide
touch controller
IP Assignment
IP Version
Auto
Manual
IPv4
The IP configuration is complete.
a. Enter the
IP Address
,
Subnet Mask
,
Gateway
,
and
DNS Server
address. A soft keyboard
appears when you tap an input field
b. Tap
Save
to save the changes, or
Undo
to
leave without saving.
IPv6
a. Tap
On
or
Off
in the
DHCP Options
section
according to your preference.
1
b. Tap
Save
to save the change, or
Undo
to
leave without saving.
a. Enter the
IP Address
and
Gateway
. A soft
keyboard appears when you tap an input field.
b. Tap
On
or
Off
in the
DHCP Options
section
according to your preference.
1
c. Tap
Save
to save the changes, or
Undo
to
leave without saving.
1
DHCP Options:
Off: All IP parameters, except the IP address and gateway, must be set manually.
Please refer to the Administrator Guide for your product for details about all settings.
On: The IP parameters, like the DNS and NTP server addresses, will be obtained automatically from the network.
Please refer to the Administrator Guide for your product for details about all settings.
On: The IP parameters, like the DNS and NTP server addresses, will be obtained automatically from the network.
Configuring IP
(when not set by a provisioning system)
Your video conference system supports both IP
version 4 (IPv4) and IP version 6 (IPv6).
In both cases, the IP parameters can be assigned
automatically by the network, or you can set everything
manually.
If you want to set the parameters manually please
contact your network administrator to obtain the
required parameters.
If an IP address is already assigned to your system, you
will find the current IPv4 and/or IPv6 address on the
System Information page:
Tap
More > Settings > System Information
.
The IPv4 Address and/or IPv6 Address of the system
is shown in the NETWORK
section.
1. Select IP version
i. Tap
More > Settings > Administrator Settings > Network
Settings
.
ii. Tap
IPv4
or
IPv6
in the
IP Version
section
according to your
requirement.
iii. Tap
Save
to save the change, or
Undo
to leave without saving.
2. Select automatic or manual IP assignment
i. Tap
Auto
in the
IP Assignment
section
if you want
automatic IP assignment; or
Manual
if you want to set the
IP addresses manually.
ii. Tap
Save
to save the change, or
Undo
to leave without saving.
3. Set the IP addresses
Set the remaining IP settings according to the table below.
The actions required depend on the IP version and IP
assignment method you selected in the previous steps.
4. Return to the main menu
Press
Exit
to return to the home menu.
Back to task overview
User interfaces
Introduction
Configuration
Table of contents
Appendices
Configuration