Руководство По Обслуживанию для Cisco Cisco TelePresence MX700

Cisco TelePresence Endpoints and Cisco Unified Communications Manager 

Deployment Guide

D15336.01 Deployment gude for TelePresence Endpoints on CUCM, DECEMBER 2015.

www.cisco.com — Copyright © 2015 Cisco Systems, Inc. All rights reserved. 

26

About endpoint configuration

You can use the Touch controller, remote control, web 

interface, or the command line interface to configure the 

endpoint. We recommend using the web interface for the 

configuration. 

NOTE:

 

You should do the CUCM configuration before the 

endpoint provisioning. 

When the endpoint is provisioned from CUCM, it will 

overrride some settings on the endpoint.

Be aware that HTTP (web interface) and SSH (used 

for command line) may be disabled in the endpoint 

configuration on CUCM. This will prevent access to the 

endpoint's web interface and command line interface. See 

 for 

how to enable/disable Web access and SSH access.

Endpoint diagnostic tools

If you are having trouble using the TelePresence endpoint 

diagnostic tools when the endpoint is provisioned to CUCM, 

check that the SIP listen port is set to Off (default). Log in to 

the web interface of the endpoint and go to: 

.

Endpoint configuration in three steps

Setting the system passphrase

It is mandatory to set a passphrase for the users to restrict 

access to system configuration. If no passphrase is set 

there will be a notification on screen.

Go to: 

"Setting the system passphrase" 

on page 27.

Setting the default call details

The 

 will not be set by CUCM. Set the call rate to 

match the network capabilities to achieve the desired call 

quality.

Go to: 

Setting up provisioning

The endpoint can be provisioned either from CUCM, or from 

CUCM via Expressway.

Go to: 

, or 

You can also read about provisioning in the Getting Started 

Guide for the endpoint 

Finding the IP address

If you are using the web interface or the command line 

interface, you will need the endpoint's IP address. 

Use the Touch controller or the remote control to find the 

address.

•  Touch controller: Tap the gear wheel icon in the upper 

left corner of the Touch panel, followed by 

. Then

open the 

 section.

•  Remote control: Navigate to the information icon in the 

upper left corner and select 

.

Contents

Introduction

CUCM configuration

Endpoint configuration

Appendices

Contact

Endpoint configuration