Руководство По Обслуживанию для Cisco Cisco TelePresence MX700

D14850.13 MX200 and MX300 Administrator Guide TC7.3, OCTOBER 2015.

Cisco TelePresence MX200 and MX300

Administrator Guide

About snapshots and remote

monitoring (TC7.3.3 and later)

Snapshots of local input sources

If the Remote Monitoring option key is installed on the video

system, snapshots of the video system’s input sources are

displayed on the Call Control page.

Snapshots are displayed both when the video system is idle,

and when in a call.

This feature may be used when administering the video

system from a remote location, for example to check the

camera view and control the camera.

Far end snapshots

If the Remote Monitoring option key is installed on the video

system, far end snapshots may also be captured. Whether or

not the Remote Monitoring option key is installed on the far

end video system, does not make any difference.

Far end snapshots are prohibited during encrypted calls.

Navigate to: Call Control

View snapshots from the input sources

Install the Remote Monitoring option key in order

to view snapshots from the selected main source

or presentation source in this area.

PLEASE BE AWARE THAT IF YOU ENABLE THE REMOTE

MONITORING OPTION YOU MUST MAKE SURE THAT YOU COMPLY

WITH LOCAL LAWS AND REGULATIONS WITH REGARD TO PRIVACY

AND PROVIDE ADEQUATE NOTICE TO USERS OF THE SYSTEM THAT

THE SYSTEM ADMINISTRATOR MAY MONITOR AND CONTROL THE

CAMERA AND SCREEN. IT IS YOUR RESPONSIBILITY TO COMPLY

WITH PRIVACY REGULATIONS WHEN USING THE SYSTEM AND

CISCO DISCLAIMS ALL LIABILITY FOR ANY UNLAWFUL USE OF

THIS FEATURE.

Contents

Introduction

System settings

Setting passwords

Appendices

Web interface