Руководство По Обслуживанию для Cisco Cisco TelePresence MX700

D14850.13 MX200 and MX300 Administrator Guide TC7.3, OCTOBER 2015.  

www.cisco.com — Copyright © 2011–2015 Cisco Systems, Inc. All rights reserved. 

15

Cisco TelePresence MX200 and MX300  

Administrator Guide

About snapshots and remote 

monitoring (TC7.3.0 to TC7.3.2)

Snapshots of local input sources

If the snapshot feature is enabled on the video system, 

snapshots of the video system’s input sources are displayed 

on the Call Control page. 

Snapshots are displayed both when the video system is idle, 

and when in a call.

This feature may be used when administering the video 

system from a remote location, for example to check the 

camera view and control the camera.

The users of the video system are notified when the 

snapshot feature is in use. A notification saying that 

the administrator is visually monitoring the room is 

displayed on the main display of the video system.

Far end snapshots

If the snapshot feature is enabled on the video system, far 

end snapshots may also be captured. Whether or not the 

snapshot feature is enabled on the far end video system, 

does not make any difference.

 

Far end snapshots are prohibited during encrypted calls.

Navigate to: Call Control

View snapshots from the input sources

Click in this area to view snapshots from the 

selected main source or presentation source. 

Snapshots of the main or presentation source 

are displayed for approximately 10 seconds. 

Enable the snapshot feature
By default, the snapshot feature is disabled.

Enable the feature using the web interface

.

•  Go to the 

 tab and select 

•  Navigate to 

 and 

choose 

On.

•  Click 

 for the change to take effect. 

Contents

Introduction

System settings

Setting passwords

Appendices

Web interface

Web interface