для Cisco Cisco IOS Software Release 12.0(17)S
Multilink Frame Relay (FRF.16)
Prerequisites
4
Cisco IOS Release 12.0(17)S
RFCs
No new or modified RFCs are supported by this feature.
Prerequisites
Multilink Frame Relay must be configured on the peer device.
Configuration Tasks
See the following sections for configuration tasks for the Multilink Frame Relay feature. Each task in
the list is identified as either optional or required.
the list is identified as either optional or required.
•
•
•
(optional)
Configuring a Multilink Frame Relay Bundle
To configure the bundle interface for multilink Frame Relay, use the following commands beginning in
global configuration mode:
global configuration mode:
Command
Purpose
Step 1
Router(config)# interface mfr interface-number
Configures a multilink Frame Relay bundle
interface.
interface.
Step 2
Router(config-if)# frame-relay intf-type dce
Configures a device to function as a DCE.
Only one end of a link should be configured as a
DCE. The other end will function as a DTE, which
is the default setting.
DCE. The other end will function as a DTE, which
is the default setting.
Note
This command can be used only if Frame
Relay switching has been enabled by
entering the frame-relay switching
command in global configuration mode.
Relay switching has been enabled by
entering the frame-relay switching
command in global configuration mode.
Step 3
Router(config-if)# frame-relay multilink bid name
(Optional) Assigns a bundle identification name to
a multilink Frame Relay bundle.
a multilink Frame Relay bundle.
Note
The bundle identification (BID) will not
go into effect until the interface has gone
from the down state to the up state. One
way to bring the interface down and back
up again is by using the shut and no shut
commands in interface configuration
mode.
go into effect until the interface has gone
from the down state to the up state. One
way to bring the interface down and back
up again is by using the shut and no shut
commands in interface configuration
mode.