Примечания к выпуску для Cisco Cisco 2106 Wireless LAN Controller
8
Release Notes for Cisco Wireless LAN Controllers and Lightweight Access Points for Release 5.0.148.2
OL-31336-01
New Features
Step 6
Click Commands > Download File to open the Download File to Controller page.
Step 7
From the File Type drop-down box, choose Code.
Step 8
In the IP Address field, enter the IP address of the TFTP server.
Step 9
The default values of 10 retries and 6 seconds for the Maximum Retries and Timeout fields should work
fine without any adjustment. However, you can change these values if desired. To do so, enter the
maximum number of times that the TFTP server attempts to download the software in the Maximum
Retries field and the amount of time (in seconds) that the TFTP server attempts to download the software
in the Timeout field.
fine without any adjustment. However, you can change these values if desired. To do so, enter the
maximum number of times that the TFTP server attempts to download the software in the Maximum
Retries field and the amount of time (in seconds) that the TFTP server attempts to download the software
in the Timeout field.
Step 10
In the File Path field, enter the directory path of the software.
Step 11
In the File Name field, enter the name of the software file (filename.aes).
Step 12
Click Download to download the software to the controller. A message appears indicating the status of
the download.
the download.
Step 13
After the download is complete, click Reboot.
Step 14
If prompted to save your changes, click Save and Reboot.
Step 15
Click OK to confirm your decision to reboot the controller.
Step 16
After the controller reboots, repeat
to install the remaining file (either the 5.0.148.2
controller software or the Cisco Unified Wireless Network Controller Boot Software 5.0.148.2 ER.aes
file).
file).
Step 17
Re-enable the WLANs.
Step 18
For Cisco WiSMs, re-enable the controller port channel on the Catalyst switch.
Step 19
Re-enable your 802.11a and 802.11b/g networks.
Step 20
If desired, reload your latest configuration file to the controller.
Step 21
To verify that the 5.0.148.2 controller software is installed on your controller, click Monitor on the
controller GUI and look at the Software Version field under Controller Summary.
controller GUI and look at the Software Version field under Controller Summary.
Step 22
To verify that the Cisco Unified Wireless Network Controller Boot Software 5.0.148.2 ER.aes file is
installed on your controller, enter the show sysinfo command on the controller CLI and look at the
Bootloader Version field. “N/A” appears if the ER.aes file is installed successfully. “Error” appears if
the ER.aes file is not installed.
installed on your controller, enter the show sysinfo command on the controller CLI and look at the
Bootloader Version field. “N/A” appears if the ER.aes file is installed successfully. “Error” appears if
the ER.aes file is not installed.
New Features
Software release 5.0.148.2 is a maintenance release and does not contain new features.
Installation Notes
This section contains important information to keep in mind when installing controllers and access
points.
points.