Примечания к выпуску для Cisco Cisco 2106 Wireless LAN Controller

After the controller reboots, repeat 

 to 

 to install the remaining file (either the 5.1.151.0 

controller software or the Cisco Unified Wireless Network Controller Boot Software 4.2.112.0 ER.aes 
file).

Re-enable the WLANs.

For Cisco WiSMs, re-enable the controller port channel on the Catalyst switch.

Re-enable your 802.11a and 802.11b/g networks.

If desired, reload your latest configuration file to the controller.

To verify that the 5.1.151.0 controller software is installed on your controller, click Monitor on the 
controller GUI and look at the Software Version field under Controller Summary.

To verify that the Cisco Unified Wireless Network Controller Boot Software 4.2.112.0 ER.aes file is 
installed on your controller, enter the show sysinfo command on the controller CLI and look at the 
Bootloader Version field. “N/A” appears if the ER.aes file is installed successfully. “Error” appears if 
the 4.2.112.0 ER.aes file is not installed.

You can use this command to verify the boot software version on all controllers except the 2106 
because the bootloader is not upgradable on the 2106 controller.

 lists the controller software releases that support specific Cisco access points. The First Support 

column lists the earliest controller software release that supports the access point. For access points that 
are not supported in ongoing releases, the Last Support column lists the last release that supports the 
access point.

1000 Series

AIR-AP1010

3.0.100.0

4.2.207.0

AIR-AP1020

3.0.100.0

4.2.207.0

AIR-AP1030

3.0.100.0

4.2.207.0

Airespace AS1200

—

4.1.171.0

1100 Series

AIR-LAP1121

4.0.155.0

—

AIR-LAP1131

3.1.59.24

—

AIR-LAP1141N

5.2.157.0

—

AIR-LAP1142N

5.2.157.0

—

1200 Series

AIR-AP1220A

3.1.59.24

—

AIR-AP1220B

3.1.59.24

—