Технические ссылки для Cisco Cisco 4100 Series Wireless LAN Controller
3/22/05
config 802.11a
OL-7427-01 Rev 1
Related Commands
•
show rogue ap summary, show rogue ap detailed
CONFIG 802.11A COMMANDS
config 802.11a
Use the following config 802.11a commands:
•
•
•
•
•
•
•
•
•
•
•
config 802.11a antMode
config 802.11a antMode
To configure the Cisco 1000 Series lightweight access point to use one internal antenna for an 802.11a
sectorized 180-degree coverage pattern, or both internal antennas for an 802.11a 360-degree omnidi-
rectional pattern, use the config 802.11a antMode command.
sectorized 180-degree coverage pattern, or both internal antennas for an 802.11a 360-degree omnidi-
rectional pattern, use the config 802.11a antMode command.
>
config 802.11a antMode <Cisco AP> <omni/sectorA/sectorB>
Syntax
config
Configure parameters.
802.11a antMode
Antenna for 802.11a Cisco Radio.
<Cisco AP>
Cisco 1000 Series IEEE 802.11a/b/g lightweight
access point name.
access point name.
omni
Use both internal antennas.
sectorA
Use only the Side A internal antenna.
sectorB
Use only the Side B internal antenna.
Defaults
internal
Examples
>config 802.11a antMode AP1 omni
Related Commands
show ap config 802.11a, config 802.11b antMode
config 802.11a beaconperiod
config 802.11a beaconperiod
In Cisco SWAN 802.11a networks, all Cisco 1000 Series lightweight access point WLANs broadcast a
beacon at regular intervals. This beacon notifies clients that 802.11a service is available, and allows the
clients to synchronize with the Cisco 1000 Series lightweight access point. To change the 802.11a
beacon period for the whole 802.11a network, use the config 802.11a beaconperiod command.
Before you change the beacon period using the config 802.11a beaconperiod command, be sure that
you have disabled the 802.11a network using the config 802.11a disable command. When you are done
beacon at regular intervals. This beacon notifies clients that 802.11a service is available, and allows the
clients to synchronize with the Cisco 1000 Series lightweight access point. To change the 802.11a
beacon period for the whole 802.11a network, use the config 802.11a beaconperiod command.
Before you change the beacon period using the config 802.11a beaconperiod command, be sure that
you have disabled the 802.11a network using the config 802.11a disable command. When you are done