Технические ссылки для Cisco Cisco 4100 Series Wireless LAN Controller

 

config 802.11b fragmentation

To configure the 802.11b/g fragmentation threshold, use the config 802.11b fragmentation command.
This command can only be used when the network is not operational.

>

config

Configure parameters.

802.11b

802.11b network parameters.

fragmentation

Fragmentation threshold.

<threshold>

Fragmentation threshold value.

None.

>config 802.11b fragmentation 6500

config 802.11a fragmentation, show 802.11a, show auto-rft

config 802.11b enable

Note that you must use this command to enable the network after configuring other 802.11b 
parameters.
Note that this command only enables the Cisco SWAN 802.11b network. To enable the Cisco SWAN 
802.11g network, you MUST have the 802.11b network enabled, and then use the config 802.11b 
11gSupport enable command. To disable the 802.11a, 802.11b and/or 802.11g networks for an indi-
vidual WLAN, use the config wlan radio command.
This command can be used any time the CLI interface is active. Note that you must reboot the Cisco 
Wireless LAN Controller to implement this command.

>

config

Configure parameters.

802.11b

802.11b network parameters.

enable

Enable 802.11b. Allow support for 802.11g.

network

For the whole network.

<Cisco 1000 Series lightweight access point>To override the network setting 

for individual <Cisco 1000 Series lightweight access 
point> Cisco Radio.

Enabled.

>config 802.11b enable network
to enable the whole 802.11b network and provide support for the 802.11g 
network. 

>config 802.11b enable AP1
to enable AP1 802.11b transmissions and support AP1 802.11g transmissions.

show sysinfo, show 802.11b, config 802.11b 11gSupport, config wlan radio, 
config 802.11b disable, config 802.11a disable, config 802.11a enable

config 802.11b fast-roaming

To configure the 802.11b/g fast roaming extensions, use the config 802.11b fast-roaming command.