Технические ссылки для Cisco Cisco 4404 Wireless LAN Controller

Deployment Guide for Cisco Guest Access Using the Cisco Wireless LAN Controller, Release 4.1

OL-13691-01

Configuring Guest Access on the Cisco Wireless LAN Controller

Figure 1

Remote Office Configuration Example

Connecting to the Neighbor Switch

The controller is connected to the neighboring Catalyst 3750 switch using only one port. The neighbor
switch port is configured as an 802.1Q trunk, and only the appropriate VLANs in this case, specifically
VLANs 30, 50 and 60 are allowed. The AP-Manager and Management interfaces are members of VLAN
50 which in this example is configured as the native VLAN in the trunk interface.

The 802.1Q switchport command-line interface (CLI) configuration is as follows:

interface GigabitEthernet1/1

description Trunk Port to Cisco WLC

switchport trunk encapsulation dot1q

switchport trunk native vlan 50

switchport trunk allowed vlan 30,50,60

switchport mode trunk

no ip address

Configuring the Cisco Wireless LAN Controller

Initial configuration of the Cisco wireless LAN controller is accomplished using a console cable
connection to the controller. The administrator can configure the system using the automatic
Configuration Wizard available on the console port.

Wireless

VLANs

Internet

WLC

Guest

EtherIP

"Guest Tunnel"

EtherIP

"Guest Tunnel"

Guest VLAN - 10.10.60.x /24
Secure VLAN - 10.1.30.x /24
Management - 10.10.50.2
AP-Manager - 10.10.50.3

Guest VLAN - 10.10.60.x /24
Secure VLAN - 10.1.30.x /24

Campus Core

LWAPP

Secure

LWAPP

Guest Secure

170446

Guest Secure