Руководство По Установке для Cisco Cisco 5760 Wireless LAN Controller

You can use either the RJ-45 console port or the USB console port. 

The first time that you connect a Windows PC to the USB console port, you are prompted to install the 
USB console driver. Follow the installation prompts to install the driver. The USB console driver maps 
to a COM port on your PC; you then need to map the terminal emulator application to the COM port. 
See the 

 for more information about the USB console 

driver.

Follow these steps to connect the PC to the controller’s console port:

If you use the CONSOLE port, plug the RJ-45 connector on a null-modem serial cable into the 
controller’s CONSOLE port and the other end of the cable into the PC’s serial port.

If you use the USB console port, plug the 5-pin mini Type B connector into the controller’s USB console 
port and the other end of the cable into the PC’s USB Type A port.

Start the PC’s terminal emulation program.

Configure the terminal emulation program for the following parameters:

9600 baud

8 data bits

No flow control

1 stop bit

No parity

Before you can use the startup wizard, you may need to obtain the information discussed in the 

. Also, you will need to know the following 

information:

Management network interface IP Address

Wireless management interface IP Address

VLAN number for the wireless management interface

At any point you may enter a question mark (?) for help. Press Ctrl-C to abort the configuration dialog 
at any prompt. Default settings are enclosed with square brackets ([]). 

Basic management setup configures only enough connectivity for management of the system, extended 
setup will ask you to configure each interface on the system.

To configure the controller for basic operation using the Startup Wizard, follow these steps:

When prompted to enter basic management setup, enter yes.

Enter the hostname, which is the name you want to assign to the controller.